Though this cpu is easier to cool than the other, it takes longer to hit 100C because it's running 125w for the remaining duration of the test, combined with the poor case airflow and small cooler. The 14700K, on the other hand, has exceeded its 253w PL2 and appears to have stayed up there the entire duration of the test. The 10700K has dropped down to the 125w PL1 state after the time limit for turbo boost(229w PL2) has expired, which is 56 seconds by default.

I can tell from your screenshots that the Omen's mobo isn't running an overclock(and following the Intel spec), but the other board is, by looking at the Powers section. The hot zones/spots on it are larger, and thus easier to transfer the thermal energy from the die up to the cpu cooler the thermal density is higher.Īll this lithography/die shrinking has brought us to a hard wall in regards to moving the heat from these tiny zones effectively. The 10700K is easier to cool due to being built on a larger lithography.

That doesn't mean the cooler isn't working - see below. 'What bothers me is the absence of a hot air flow from the CPU radiator.' If you're going to be running benchmarks/stress tests like that, you should be experimenting with your own custom settings, and not the motherboard defaults. If I see that the processor is at 100 degrees but there's no hot air flow from the radiator, I assume it's not cooling properly, especially if it's reaching 100 degrees within 3 minutes. However, here, I don't observe any hot air flow, and it worries me. As I mentioned earlier, in my previous computer, when I ran a benchmark, the CPU radiator fan would kick in after about three minutes, running loudly, and there was a noticeable hot air flow. What bothers me is the absence of a hot air flow from the CPU radiator. I am attaching a screenshot of the temperature. The CPU cooling involves a top-mounted cooler and air intake from the front through three fans, while the air is pushed out at the back by one 12-inch fan.

As I mentioned before, the computer is built from scratch. Additionally, I check the temperature using HWMonitor Pro 1.53 圆4. The program I use is LinX-0.6.5 for Windows. I have written the configuration of the computer. 'I will be more understandable this time.

Instal HWMonitor Pro 1.53